Swapping a worn Bowden PTFE tube for Capricorn is usually straightforward, but under-extrusion is often caused by a tiny gap or a bad cut. This guide shows the
XY belt tension directly affects dimensional accuracy by controlling slop (backlash) and stretch. Learn how to separate belt slop from over-tension, measure
Streaks, banding, and cloudiness usually come from a small set of root causes: dirty screens/vats, exposure calibration drift, leveling/Z issues, lift/retract
Resin “stringing” (ropes, tails, and whiskers) usually comes from a mix of overexposure, temperature/viscosity, and lift/drain timing. Here’s how to diagnose
Heat creep happens when heat migrates upward into the colder parts of your hotend, softening filament where it shouldn’t. This guide covers the symptoms,
Replacing a worn nozzle is usually straightforward, but the heat break can get damaged if you remove or tighten the nozzle the wrong way. This guide walks you
A direct-drive upgrade changes how filament feeds and how pressure builds in the hotend. This guide walks you through mounting, cable routing, firmware
Cloudy resin and premature wear usually come from contamination and cured “debris” in the vat. Follow daily and weekly routines to keep the FEP film and LCD
Dialing Z offset isn’t just “lower the plate.” Learn how leveling, exposure compensation, and recoat timing work together to prevent first-layer suction
Replacing a scratched or cloudy FEP film is one of the fastest ways to restore clean LCD resin prints. This guide walks you through safe handling, fitting,
